CONVERTER
NEWWhen used with a compatible flash, HSS/TTL shooting is possible. In HSS mode, shutter speeds up to 1/8000 are supported. For Canon products.
CONVERTER
NEWWhen used with a compatible flash, HSS/TTL shooting is possible. In HSS mode, shutter speeds up to 1/8000 are supported. For Canon products.
CONVERTER
A device that converts strobe light emission signals into LED light. The battery level check function reduces the risk of not being able to emit light due to a dead battery.
Only manual flash is supported. Driving time is about 100 hours.
CONVERTER
A device that converts strobe light emission signals into LED light. The battery level check function reduces the risk of not being able to emit light due to a dead battery.
Only manual flash is supported. Driving time is about 100 hours.
CONVERTER
A device that converts strobe light emission signals into LED light. The battery level check function reduces the risk of not being able to emit light due to a dead battery.
Only manual flash is supported. Driving time is about 100 hours.
CONVERTER
Converts the Canon EOS R's TTL signal to a light signal. Therefore, strobes can be fired as quickly as the strobes' recycle time.
※Compatilbe strobes: YS-D3 MKII, YS-D3, YS-D2 and YS-D1.Mechanical specifications are the same as other Optical YS Converters.
※Sea&Sea Optical Converter Firmware Update for YS-D3.
CONVERTER
A compact unit that converts the camera's TTL signal to a light signal. The converter can be mounted on the camera's accessory shoe and can be connected to (a) SEA&SEA strobe(s) with Fiber-Optic Cable(s). TTL and manual modes can be switched by pushing the mode switch on the housing.
Points to Note When Using the Light Converter C2 in Combination with the 5D Mark IV and YS-D2 Flash
With the above combination, there is a possibility that the light may fail to synchronize when used on land with the 100/120 diffuser attached. If this occurs, please remove the diffuser before using the light. If the light synchronizes properly with the diffuser removed, there is no problem with the product.
Underwater, the above issue will not occur even if the diffuser is attached when the light is used.
※Sea&Sea Optical Converter Firmware Update for YS-D3
CONVERTER
A compact unit that converts the camera's TTL signal to a light signal. The converter can be mounted on the camera's accessory shoe and can be connected to (a) SEA&SEA strobe(s) with Fiber-Optic Cable(s). TTL and manual modes can be switched by pushing the mode switch on the housing.
Points to Note When Using the Light Converter C2 in Combination with the 5D Mark IV and YS-D2 Flash
With the above combination, there is a possibility that the light may fail to synchronize when used on land with the 100/120 diffuser attached. If this occurs, please remove the diffuser before using the light. If the light synchronizes properly with the diffuser removed, there is no problem with the product.
Underwater, the above issue will not occur even if the diffuser is attached when the light is used.
※Sea&Sea Optical Converter Firmware Update for YS-D3
CONVERTER
A compact unit that converts the camera's TTL signal to a light signal. The converter can be mounted on the camera's accessory shoe and can be connected to (a) SEA&SEA strobe(s) with Fiber-Optic Cable(s). TTL and manual modes can be switched by pushing the mode switch on the housing.
※The Sony genuine adapter “ADP-MAA” is no longer required to connect to the camera.
Copyright (C) SEA&SEA Co., Ltd. All Rights Reserved.