Optical YS Converter/N can be built into the housing
Compatible with new Optical YS Converter/N1 for MDX housing which converts the camera’s TTL signal to a light signal. Both TTL and manual strobe photography is possible using a Fiber-Optic Cable II.
* Optical YS Converter details will be announced later.
By attaching the VF180 (#46112) or the VF45 prism viewfinders (#46111) (magnification ratio of 1.2x) to the housing, the magnification increases by 1.2x and entire field of view can be seen at the same time. Recommended for users committed to strict composition and focusing.
* You may encounter some difficulties to access the delete button function if VF45 1.2x is installed on the housing. To avoid this problem, manufacturer suggests using VF180 1.2x instead.
Port can be replaced without opening the housing
Port lock can be now activated from outside the housing. The housing is also equipped with a ‘lens-lock release’ button which allows the lens to be replaced without opening the housing. The port lock can also be activated from inside like previous SEA&SEA housings.
*1 The housing is not equipped with any strobe connector when shipped from the factory. Use Fiber-Optic Cable(s) when connecting external strobe(s). Optional Sync Cord 2-pin Connector is required if you wish to use a conventional sync cable.
SEA&SEA MDX-D7100 Housing: Compatibility with Nikon D7200.
MDX-D7100 housings sold from now on are compatible with both Nikon D7100 and D7200 cameras. However, MDX-D7100 housings with the following serial numbers may require a small modification to the Mode Dial Lock Button on the rear case. Without modification, it may be difficult to depress and turn the button. In this case, please contact the official SEA&SEA distributor in your area.
131100001 - 131100196, 131100201, 131100209 - 131100216, 131100209 - 131100216, 131100221 - 131100225 and 13100250.
All other controls and the Optical YS Converter/N1 for MDX housing can be used without modification.